Listen for clear and balanced sound from your speakers.īy following this step-by-step guide, you can confidently install banana plugs on your speaker wires, enhancing your audio setup with a clean and professional connection. Test: Turn on your audio system and play some music to test the newly installed banana plugs. Repeat for Speakers: Repeat the process for the other end of the speaker wire, connecting the banana plug to the speaker's terminals.ĭouble-check: Ensure that all connections are secure and properly seated in the terminals. For most banana plugs, you'll need to insert the plug and then twist it gently to secure it in place. Insert Banana Plug: Insert the banana plug into the appropriate terminal. Some terminals are designed to accept banana plugs directly, while others may require you to unscrew the binding posts slightly. Step 3: Connecting Banana Plugs to Speakers and AmplifiersĪmplifier/Receiver: Locate the speaker terminals on your amplifier or receiver. Screw Outer Casing: If applicable, screw the outer casing of the banana plug back onto the assembly, covering the metal collar and providing a clean finish. The collar's pressure should hold the wire strands firmly. Tighten Collar: Once the wire is inserted, screw the metal collar down to secure the wire in place. Make sure each strand is securely in place. Insert Wire: Insert the separated wire strands into the plug's metal collar. Separate Wire Strands: Gently twist and separate the strands of wire to prevent fraying. Slide the casing over the speaker wire with the threads facing away from the stripped end. Prepare Banana Plugs: If your banana plugs require assembly, unscrew the plug's outer casing. Be cautious not to cut into the actual wire strands. Strip: Use a wire stripper or scissors to carefully strip about 1/2 to 3/4 inch of insulation from the ends of the speaker wire. Cut the wire to the desired length using wire cutters. Measure: Determine the length of speaker wire you'll need to connect your speakers to your amplifier or receiver. Heat gun or lighter (if using heat shrink tubing) Install rear compression screw securing cable to banana plug.Banana plugs (matching the size of your speaker terminals)īanana plug installation tool (if included) Insert compression slug first into the banana plug. Ensure that conductors do not interfere with rear compression screw threads. Fan wire (up to 12 AWG) and fold conductors over the rear compression screw. Insert speaker cable into rear compression screw. Remove approximately 1/4" of insulation from speaker cable. Rear entry cable installation: Remove rear compression screw and compression slug from banana plug. Tighten rear compression screw to secure wire. Insert exposed wire (up to 10 AWG) into side opening. Remove approximately 5/16" of insulation from speaker cable. Instructions: Side entry cable installation: Loosen rear compression screw in counter clockwise fashion to expose side opening on banana plug. Sold in pairs: 1-red and 1-black per package. Also accepts rear-entry banana plugs for stacking. Side-entry accepts up to 10 gauge wire while the rear-entry accepts up to 12 gauge wire. The floating "slug" allows tight wire compression without the twisting effect on the wire strands that other compression connectors have. Knurled barrel and compression nut with floating "slug". Parts Express Banana Plug Pair Compression Type
0 Comments
Leave a Reply. |
AuthorWrite something about yourself. No need to be fancy, just an overview. ArchivesCategories |